I have a Raynor "Safety Signal" (Model 3265RGD 1/2 HP) opener.

[?] Subscribe To This Site

I have a Raynor "Safety Signal" (Model 3265RGD 1/2 HP) opener.

by Terry Johnson
(Xenia, Ohio)

Both "Safety Signal" remotes stopped working. Both batteries are OK. The unit on our wall still operates OK. I have tried all the "LEARN" steps to re-enter the code and checked the "safety" lights and they are both brightly lit. I am at a loss to try something else.

Comments for
I have a Raynor "Safety Signal" (Model 3265RGD 1/2 HP) opener.

Average Rating

Click here to add your own comments

Dec 20, 2010
Rating

You Rock!
by: Anonymous

You guys rock. Couldn't figure out why I had to hold the button down the whole time to make it close. One of the safety lights was loose. Tightened it up and it works like a charm!

Dec 12, 2010
Rating

Program Remotes
by: Donald

First, make sure the antenna is fully extended downward from the back of the motor assembly.

Next, you should try erasing all codes, then reprogram each remote separately.

Which garage door opener do you have?

Dec 12, 2010
Rating

Wall control unit?
by: Anonymous

Do you have to hold the button down on the wall control until the door closes completely? If so, the safety sensors are probably out of alignment.

What garage door opener do you have?

Click here to add your own comments

Join in and write your own page! It's easy to do. How?
Simply click here to return to Questions

Did you really pay full price for that?

I have a Raynor "Safety Signal" (Model 3265RGD 1/2 HP) opener.

Comments for I have a Raynor "Safety Signal" (Model 3265RGD 1/2 HP) opener.

Comments for
I have a Raynor "Safety Signal" (Model 3265RGD 1/2 HP) opener.