wall button works remotes WILL NOT

by paul
(dallas texas)

i have a 93 genie screw drive the wall button goes up and down no prob. but the remotes wont work .

i replaced the reciever board but that didnt fix it What Now?

---

The garage door not closing unless you hold the wall control button in until it

is fully closed is a very common problem. Your safety sensors are out of

alignment.

There is one on each side of your garage door, near the bottom.

They should both be at the same height. If you get down to eye level you can see

that the indicator light on the recieving unit is blinking rapidly.

Twist the sending unit until the bracket bends slightly. When they are properly

aligned, the indicator light will stay on constantly with no blinking.